[a / b / c / d / e / f / g / gif / h / hr / k / m / o / p / r / s / t / u / v / vg / vr / w / wg] [i / ic] [r9k / s4s / vip / qa] [cm / hm / lgbt / y] [3 / aco / adv / an / asp / bant / biz / cgl / ck / co / diy / fa / fit / gd / hc / his / int / jp / lit / mlp / mu / n / news / out / po / pol / qst / sci / soc / sp / tg / toy / trv / tv / vp / wsg / wsr / x] [Settings] [Search] [Home]
Board
▼ Settings Home
/3/ - 3DCG
Return Catalog Bottom Refresh
Thread archived.
You cannot reply anymore.
[Return] [Catalog] [Bottom]
Anonymous Archived
Tolerance/clearance 3d printin(...) 11/21/18(Wed)14:32:51 No.651664
File: block.jpg (50 KB, 960x505)
50 KB
50 KB JPG
Tolerance/clearance 3d printing Anonymous 11/21/18(Wed)14:32:51 No.651664 Archived
Anyone who has a CR-10 test their print tolerances with a tolerance block?

If you haven't I made one on https://grabcad.com/library/tolerance-block-1

I am considering getting a CR-10 as my first printer and would appreciate if someone would report back their tolarance results.

For example on a Stratus Uprint at my school.
>10.1 you need a hammer and can't get back out
>10.2 tight fit very hard to remove
>10.3 loose fit is firm but removable
>10.4 clearance fit
>10.5 slightly looser clearance fit
[Return] [Catalog] [Top]
Post a Reply
Return Catalog Top Refresh
Delete Post: [File Only] Style:
[Disable Mobile View / Use Desktop Site]

[Enable Mobile View / Use Mobile Site]

All trademarks and copyrights on this page are owned by their respective parties. Images uploaded are the responsibility of the Poster. Comments are owned by the Poster.