[a / b / c / d / e / f / g / gif / h / hr / k / m / o / p / r / s / t / u / v / vg / vr / w / wg] [i / ic] [r9k / s4s / vip / qa] [cm / hm / lgbt / y] [3 / aco / adv / an / asp / bant / biz / cgl / ck / co / diy / fa / fit / gd / hc / his / int / jp / lit / mlp / mu / n / news / out / po / pol / qst / sci / soc / sp / tg / toy / trv / tv / vp / wsg / wsr / x] [Settings] [Home]
Board
Settings Home
/3/ - 3DCG



Thread archived.
You cannot reply anymore.



File: Clip_2.jpg (157 KB, 988x953)
157 KB
157 KB JPG
Ok /3/ Ive been trying this for hours and I dont get how I can fix it.

Zbrush, I extruded using Qmesh from Zmodeler the green polys.
As you can see the mesh is duplicated and I want to get rid of one side of it, because the moment I give it width it always gets both instead.

Any solutions? How can I delete just one side? Any selection tools without having to select one polygon by one? -Mesh is twisted-
>>
>>611186
Posting this has probably taken you more time than just selecting the damn polygons with a brush selection.

Or just use loop select on the faces. Seriously, it takes like 20 seconds.
>>
>>611186
Auto poly group if they're not connected




Delete Post: [File Only] Style:
[Disable Mobile View / Use Desktop Site]

[Enable Mobile View / Use Mobile Site]

All trademarks and copyrights on this page are owned by their respective parties. Images uploaded are the responsibility of the Poster. Comments are owned by the Poster.