[a / b / c / d / e / f / g / gif / h / hr / k / m / o / p / r / s / t / u / v / vg / vr / w / wg] [i / ic] [r9k] [s4s] [vip] [cm / hm / lgbt / y] [3 / aco / adv / an / asp / biz / cgl / ck / co / diy / fa / fit / gd / hc / his / int / jp / lit / mlp / mu / n / news / out / po / pol / qst / sci / soc / sp / tg / toy / trv / tv / vp / wsg / wsr / x] [Settings] [Home]
Board
Settings Home
/3/ - 3DCG



Thread archived.
You cannot reply anymore.



File: Deathstroke.png (2.08 MB, 1500x750)
2.08 MB
2.08 MB PNG
I have been working on deathstroke mask for 3d printing and it keep crashing during print. Using meshmixer and cura for printing. sides are too thin and I cannot for the life of me figure out how to thicken then. I have youtubed and extruding does nothing.
>>
seriously nobody is willing to help?
>>
Ever browsed edit mode?

There's an option called Make Solid
>>
You want someone to finish it for you?
>>
>>539498
dont think you fill find many people who 3d print here
also is this an thickness problem or not, since you seem not to be sure yourself
if its is then just upload the file someone can modify it for you, and if not then i dont know what you expect



Delete Post: [File Only] Style:
[Disable Mobile View / Use Desktop Site]

[Enable Mobile View / Use Mobile Site]

All trademarks and copyrights on this page are owned by their respective parties. Images uploaded are the responsibility of the Poster. Comments are owned by the Poster.