[a / b / c / d / e / f / g / gif / h / hr / k / m / o / p / r / s / t / u / v / vg / vr / w / wg] [i / ic] [r9k] [s4s] [vip] [cm / hm / lgbt / y] [3 / aco / adv / an / asp / biz / cgl / ck / co / diy / fa / fit / gd / hc / his / int / jp / lit / mlp / mu / n / news / out / po / pol / qst / sci / soc / sp / tg / toy / trv / tv / vp / wsg / wsr / x] [Settings] [Home]
Board
Settings Home
/3/ - 3DCG

[Advertise on 4chan]


Thread archived.
You cannot reply anymore.



File: example.png (16 KB, 1632x865)
16 KB
16 KB PNG
ok so here the deal im new to cad and im dumb as hell

so i been working on this and i need to make the two areas facing away from the part flat so it goes up at an angle like a pyramid
i had tried making a wedge and a loft but its at a odd angle

any advice ?

im also using freecad
>>
I'm not sure what you are asking...
Can you point it out?
>>
>>538215
ill do my best

so the tip of the triangle piece

i want a taper from the the tip going up to the base that is connected to the rest of the part in the picture
>>
File: example.png (25 KB, 1084x770)
25 KB
25 KB PNG
so in short im trying to turn the image there to somthing like this other image

sorry im bad at this



Delete Post: [File Only] Style:
[Disable Mobile View / Use Desktop Site]

[Enable Mobile View / Use Mobile Site]

All trademarks and copyrights on this page are owned by their respective parties. Images uploaded are the responsibility of the Poster. Comments are owned by the Poster.