[a / b / c / d / e / f / g / gif / h / hr / k / m / o / p / r / s / t / u / v / vg / vr / w / wg] [i / ic] [r9k] [s4s] [vip] [cm / hm / lgbt / y] [3 / aco / adv / an / asp / biz / cgl / ck / co / diy / fa / fit / gd / hc / his / int / jp / lit / mlp / mu / n / news / out / po / pol / qst / sci / soc / sp / tg / toy / trv / tv / vp / wsg / wsr / x] [Settings] [Home]
Board
Settings Home
/3/ - 3DCG

[Advertise on 4chan]


Thread archived.
You cannot reply anymore.



File: inthepipe.png (3.03 MB, 3300x2550)
3.03 MB
3.03 MB PNG
>Solidworks
I modeled this as a basic sketch can i convert to sheet metal?
>>
fuck off theres a question thread
>>
>>536457
Insert>Sheet metal>Convert to sheet metal.
Select a stationary face as the blue part, then select a face near it where it bends and click collect all bends, click the green button and voila.
>>
File: thanks anon.png (87 KB, 1080x549)
87 KB
87 KB PNG
>>536490
super thanks bro. fuck the other anon




Delete Post: [File Only] Style:
[Disable Mobile View / Use Desktop Site]

[Enable Mobile View / Use Mobile Site]

All trademarks and copyrights on this page are owned by their respective parties. Images uploaded are the responsibility of the Poster. Comments are owned by the Poster.