[a / b / c / d / e / f / g / gif / h / hr / k / m / o / p / r / s / t / u / v / vg / vr / w / wg] [i / ic] [r9k] [s4s] [cm / hm / lgbt / y] [3 / aco / adv / an / asp / biz / cgl / ck / co / diy / fa / fit / gd / hc / his / int / jp / lit / mlp / mu / n / news / out / po / pol / qst / sci / soc / sp / tg / toy / trv / tv / vp / wsg / wsr / x] [Settings] [Home]
Board
Settings Home
/3/ - 3DCG

[Advertise on 4chan]


Thread archived.
You cannot reply anymore.



File: Driver.webm (340 KB, 1920x1080)
340 KB
340 KB WEBM
For cinema4d idiots out there, how the fuck should I make this mountain flow well from one to the other, I get this one frame at the end that's fucked, as well as it not being the EXACT same spot on both mountains? I'm pretty new to 3D animation, so, pointers welcome.
>>
>>529650
measure camera locations and reposition it according to measurements
>>
>>529657
thanks m88
>>
>>529650
I would of modeled the mountains in a loop like a track with an open area for the camera in the middle, making them flow seamless into each other with the geometry then just animated the camera to spin 360 degrees at the center. Should be naturally seamless after that.

But if you couldn't have done that based on what your doing then >>529657 's method should work.
>>
>>529658
NP :v



[Advertise on 4chan]

Delete Post: [File Only] Style:
[Disable Mobile View / Use Desktop Site]

[Enable Mobile View / Use Mobile Site]

All trademarks and copyrights on this page are owned by their respective parties. Images uploaded are the responsibility of the Poster. Comments are owned by the Poster.