[a / b / c / d / e / f / g / gif / h / hr / k / m / o / p / r / s / t / u / v / vg / vr / w / wg] [i / ic] [r9k] [s4s] [cm / hm / lgbt / y] [3 / aco / adv / an / asp / biz / cgl / ck / co / diy / fa / fit / gd / hc / his / int / jp / lit / mlp / mu / n / news / out / po / pol / qst / sci / soc / sp / tg / toy / trv / tv / vp / wsg / wsr / x] [Settings] [Home]
Board
Settings Home
/3/


Hi all,

How can I get these rings on the top of the table repeating around itself from center like the reference photo's table has? Rings should be one size.

This model is my sketch and I attempt to archive structure of tables from the reference photo.
I've made this base model with help of duplifaces (the orange circle )
>>
>>507823
array
>>
can you extrude a spline/shape into a mesh in Blender? if so, just create a spline circle, duplicate/ scale as desired, and extrude them all.
>>
File: blender thing.png (807.81 KB, 1920x1620)
807.81 KB
807.81 KB PNG
Is this what you want to do?
>>
>>507823
Procedural:

1. Array of offset circles following leg profiles. (curve)
2. Revolve them all 360 degrees. (array again)
3. Walk away.
>>
Could also "spin" all the ring profiles.

http://www.blender.org/manual/modeling/meshes/editing/duplicating/spin.html



Delete Post: [File Only] Style:
[Disable Mobile View / Use Desktop Site]

[Enable Mobile View / Use Mobile Site]

All trademarks and copyrights on this page are owned by their respective parties. Images uploaded are the responsibility of the Poster. Comments are owned by the Poster.