[a / b / c / d / e / f / g / gif / h / hr / k / m / o / p / r / s / t / u / v / vg / vr / w / wg] [i / ic] [r9k] [s4s] [cm / hm / lgbt / y] [3 / aco / adv / an / asp / biz / cgl / ck / co / diy / fa / fit / gd / hc / his / int / jp / lit / mlp / mu / n / news / out / po / pol / qst / sci / soc / sp / tg / toy / trv / tv / vp / wsg / wsr / x] [Settings] [Home]
Board
Settings Home
/3/


So I started taking a look at 3d kasuko again after a few years, and starting thinking about if there is a way to edit a .tah/.tso file for mods that don't properly fit the NJXA body.

Long story short, I tried rebuilding a new .tah file after increasing the y axis on a mod that sat too low, and nothing happened in the end result. Is there someone with a bit more knowledge/experience in adjusting the mod files manually?

Also, I couldn't tell if this category was correct, or if JP would have been better. If not, my apologizes.
>>
File: PORTR_1.png (362.63 KB, 640x480)
362.63 KB
362.63 KB PNG
>>501172
HONGFIRE had links to tools for adding/removing content from this hentai game, and of course you need to also have metasequoia installed. I remember loading the models directly into 3ds max, but this was a long time ago. Of course, bonnig and animation would be completely up to you.



Delete Post: [File Only] Style:
[Disable Mobile View / Use Desktop Site]

[Enable Mobile View / Use Mobile Site]

All trademarks and copyrights on this page are owned by their respective parties. Images uploaded are the responsibility of the Poster. Comments are owned by the Poster.